Manual download
点击下载
Download
Introduction
1
Multifunctional Lift Instruction Manual
Important Information:Before the machine is powered on , please be sure to vertically lift and fix it . And make sure that the end of the cable is loaded !
Fixing Method:Vertical lifting
Power supply and Signal connection :
Input Power : 90-220V Stand-alone peak power 75W Each series can be connected in 30 units .
DMX Control line : The "1" core is a braided shielded cable , each series can be connected in 30 units .
Control and Programming :
(MA/Pearl2010/Tiger Touch)
The connection diagram is as below :
Recommend use :
The connection diagram is as below :
Basic Function :
MODE UP DOWN ENTER
Instructions: Press 『UP』 or 『DOWN』 to modify the value . Press 『ENTER』 to confirm and save .
Channel Description :
No. | Function | Description |
1st Channel | Lifting (Position) | 0→255: down; 255←0: up |
2nd Channel | Speed | 0→254: Speed(from fast to slow), 255: brake(pause) |
3rd Channel | Total dimming | 0→255: Total dimming,from dark to bright |
4th Channel | R (Red) | R dimming , from dark to bright |
5th Channel | G (Green) | G dimming , from dark to bright |
6th Channel | B (Blue) | B dimming , from dark to bright |
Use Stroke setting :
In any function mode , press and hold the 『MODE』 + 『UP』 button at the same time to enter the use stroke selection menu , select the code corresponding to the stroke . Press 『ENTER』to confirm the save , and automatically return to the function mode after 3 seconds . | ||
No. | Display Code | Description |
1 | L010 | Use the length 1 meter |
2 | L020 | Use the length 2 meters |
3 | L030 | Use the length 3 meters |
And so on ...... |
Speed model :
In any state, press and hold 『MODE』+『ENTER』 at the same time to enter the lifting speed selection mode. The code “S001” is the low speed, the winding speed is 1 m/s ; the code "S002" is the fast speed mode, and the winding speed is 1.5 m/s. (Factory default low speed mode)
Brake switch delay time :
Delay time:When the motor is not operating , the waiting time for the brake switch to automatically lock .
In any function mode , at the same times , press 『UP』 + 『ENTER』 , enter the brake switch delay time selection mode . Press 『UP』 or 『DOWN』 to scroll the code . The code “ T001” means the delay time is 1 minute , and the code “T002” delay times is 10 minutes , the “T003” indicates no delay time , and the brake switch is open .
●This manual is only suitable for this model products , if any update without notice .